ChaseCam PDR 100 Bedienungsanleitung PDF herunterladen (Seite 14)

Traqmate basic and classic User Manual V3.40 March 27, 2013

Power Connection

In all installations, the SU must be supplied with a power source at all times it is in operation. For

Traqmate Complete, the DU can receive power via the SU-DU connection cable from the SU or

via the USB cable when connected to a PC for uploading sessions.

The SU was designed to be powered from a +12 VDC battery supply in four different ways; a

permanent wiring harness in the vehicle, a cigarette lighter adapter, a battery pack, and a wall

charger. Each of these will be discussed

separately.

Cigarette Lighter Adapter

For installations where a permanent power supply

connection is not required or desired, the cigarette

lighter adapter offers a quick and convenient solution. This adapter can be secured to the SU by

inserting the plug into the power connector (PWR) on the SU and tightening the threaded nut to

the power (PWR) socket. Once the SU and the power connector have been secured, the

cigarette lighter adapter can be plugged into one of the cigarette lighter sockets located in the

vehicle. It should be noted that many automobiles have cigarette lighter sockets that are always

ON and do not turn the power off when the ignition switch has been turned to the OFF position.

The cigarette lighter adapter has a RED LED to indicate that vehicle battery power is presented to

the adapter. During extended vehicle idle periods, the cigarette lighter adapter should be

removed from the vehicle socket to prevent vehicle battery drain.

TraqPaq Rechargeable Li-ion Battery Pack

The TraqPaq Rechargeable is very convenient and has the

advantage of reusability. The TraqPaq Rechargeable Battery

Pack is capable of powering a Traqmate for 7-10 hours on a

full charge.

If not handled properly Li-ion batteries can be dangerous.

Traqmate Li-ion packs have a protection circuit for

overcharge and excessive discharge and should provide

years of service under normal circumstances. If the pack

ever starts to overheat or swell, discontinue use immediately.

To recharge the pack, just plug it into the Traqmate Li-i

on charger. It will recharge in

approximately 2 hours, at which time the LED on the charger will change from red to green.

Only use the Traqmate charger with Traqmate Li-ion Rechargeable battery packs. Never charge

any other types of batteries using the Li-ion charger. This includes alkaline or NiCd or NiMH

batteries in a non-rechargeable TraqPaq.

Permanent Wiring Harness Installation

The power cable is a 13 foot, two conductor, red and black zip

cable that has a plug on one end and is not terminated on the

other end. The power plug contains a threaded nut for

securing the plug to the power jack (PWR) on the Traqmate

Sensor Unit (SU). The other end of the cable is intended to

connect to either the automobile battery or a junction box.

Since the SU mounting location can vary widely (trunk, under

seat, floorboard, etc.) the required cable length will also vary.

Consequently, the cable can be cut to an appropriate length suitable for your automobile, once

the mounting location is selected.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

ChaseCam PDR 100 Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamerarekorder ChaseCam PDR 100